Skip to content
UnderYourHouse

Radon mitigation basics and cost

By Chris · Last reviewed

Most radon systems work the same way: a pipe and a fan pull soil gas from under the house and vent it above the roofline before it can get inside. EPA calls this soil suction (Consumer's Guide to Radon Reduction).

A radon fan and white vent pipe mounted on the side of a house, with a small pressure gauge on the pipe
A radon fan and vent pipe on the outside of a house. The small gauge on the pipe shows the system is pulling air.

By foundation type

Basement and slab homes

Sub-slab suction runs a pipe through the floor slab into the gravel or soil below. The fan creates a slight vacuum under the slab, so radon goes out the pipe instead of up into the house.

Crawlspace homes

EPA describes covering the earth floor with a high-density plastic sheet, then using a vent pipe and fan to draw radon from under the sheet. This is called submembrane suction, and EPA says that, properly applied, it is “the most effective way to reduce radon levels in crawlspace homes.”

EPA calls the alternative, active crawlspace depressurization (pulling air straight out of the crawlspace with a fan), less favorable. It generally does not work as well, it needs extra attention to combustion appliances backdrafting and to sealing the crawlspace off from the house, and it can raise energy costs.

Planning crawlspace work too?

If you are also adding a vapor barrier or sealing the crawlspace, plan the radon system at the same time. A submembrane radon system needs a plastic sheet over the crawlspace floor, so ask whether one sheet can serve both jobs instead of laying the floor twice. See vapor barriers and encapsulation.

Sealing cracks

Sealing cracks helps other methods work, but EPA does not recommend sealing alone: by itself it has not been shown to lower radon levels significantly or consistently.

What it costs

There is no current neutral price range.EPA's 2025 consumer guides no longer give a dollar range. They say mitigation costs are typically comparable to other common home repairs, that costs vary widely, and that you should get one or more estimates from qualified mitigators (EPA).

The only current EPA dollar figure is a modeling assumption, not a quote: EPA's October 2025 cost-benefit analysis assumed about $1,826 to install an active soil depressurization system, about $206 a year to run it, and about $476 to replace the fan every 10 years, all in 2023 dollars (EPA, 2025). Your price depends on your foundation, your soil, and how many suction points the house needs.

We don't quote contractor or cost-aggregator ranges, because they are written by people selling the work. Your state radon office can tell you what is typical locally.

Living with a system

  • The fan runs all the time. EPA says it should never be turned off.
  • Check the warning device, usually a manometer (a small gauge on the pipe), regularly.
  • Fans often last five years or more, and then may need repair or replacement.
  • Retest after the system goes in, and at least every two years after that. A continuous monitor can show day-to-day changes in between.

Related guides

Find your county's radon zone, climate zone and local testing contacts

General information, not professional or medical advice. Conditions vary from house to house. Test your own home, and talk to a certified professional, your local health department or your doctor before you act on anything here.