Skip to content
UnderYourHouse

Signs of crawlspace moisture and mold

By Chris · Last reviewed

Crawlspace moisture problems usually start small and out of sight. A twice-a-year look, after a wet spell in spring and in the humid part of summer, catches most of them early.

Signs from inside the house

  • A musty or earthy smell, especially on humid days or when the heat or air first comes on.
  • Floors that feel soft, bouncy or cold, or wood floors that cup or gap.
  • Condensation or rust on ducts, pipes or the air handler, if they are in the crawlspace.
  • More insects, such as silverfish, or more spiders, near floor level.

Signs in the crawlspace

  • Standing water or wet soil, or mud lines on the walls from past water.
  • Water on top of the vapor barrier, or a barrier with gaps, tears or loose edges.
  • Sagging or wet insulation between the floor joists, or insulation lying on the ground.
  • Fuzzy or spotted growth, white, green or black, on joists, beams or the underside of the floor.
  • Sweating ducts or pipes, or drips under them.
  • White crust (efflorescence) on block walls, a sign water is moving through them.
  • Rot: wood that is dark, soft, crumbly or easy to push a screwdriver into.

Be careful going in

Crawlspaces can have exposed wiring, sharp fasteners, pests and poor air. Take a good light, gloves and eye protection, and a respirator if there is visible mold. If you're not comfortable, have an inspector or other professional look.

Measure it

A pin-type moisture meter on the floor framing tells you more than a look. USDA's Forest Products Laboratory says wood kept at 20% moisture content or lessis protected from decay fungi, and that serious decay happens only above the fiber saturation point (about 30%). Humid air alone won't wet wood enough for serious decay, but it can let some molds grow (Wood Handbook, Ch. 14).

A cheap hygrometer left in the crawlspace shows relative humidity over time. Readings that stay high through summer are a sign outside air or ground moisture is getting in.

What to fix first

  1. Stop liquid water. Gutters, downspout extensions, grading, plumbing leaks, and drainage or a sump pump if groundwater comes up.
  2. Cover the ground. A complete vapor barrier stops a lot of moisture coming up from the soil.
  3. Deal with the air. In humid climates that may mean sealing the crawlspace and drying the air; see vented vs. sealed crawlspaces.
  4. Then clean up mold and replace wet insulation, once the space stays dry. Cleaning first, before the water is fixed, usually means doing it twice.

Health concerns about mold are a question for your doctor. Your county or state health department can also advise. See your state page.

Related guides

Find your county's radon zone, climate zone and local testing contacts

General information, not professional or medical advice. Conditions vary from house to house. Test your own home, and talk to a certified professional, your local health department or your doctor before you act on anything here.